The cable clips are a critical part of your Unlimited Kit and are designed to keep your cables in place and secure.
In your product manual, we originally suggested mounting the cable clips on the inside truck mounting bolts (the ones closer to the motor controller and the battery).
After extensive testing we've found that there is a potential for the cables to disconnect under vibration when secured in this fashion.
Therefore, we have now updated our installation instructions.
The correct placement of the cable clips is on the outer truck mounting bolts (the ones closer to the tail of the board).
To install your cable clip, wrap it around the thick part of the motor cable and then push the cable clip holes over the outer truck mounting bolt. This may take a little effort, but the fit should be snug. Place the nut over both ends of the clip and tighten down with a skate tool until the nut and clip are secure.
You're good to go!
Additional diagrams and photos for reference:
Comments
0 comments
Please sign in to leave a comment.